RIGOL Chapter 7 Digital Voltmeter (DVM) and Frequency Counter
7-4 DS8000-R User Guide
Frequency Counter
The frequency counter analysis function provides frequency, period, or edge event
counter measurements on any analog channel.
The following methods are available for you to enter the frequency counter setting
menu:
âš« Click on the function navigation icon at the lower-left corner of the screen
to open the function navigation. Click on the "Counter" icon to enter the
frequency counter setting menu.
âš« Click on the "MEASURE" label at the top of the screen, then click the "Analyze"
tab to select "Counter" to open the frequency counter setting menu.
âš« Click on the function navigation icon , then select Measure, then click Add.
In the displayed measurement category area, click to select "Analyze", and then
select "Counter" to open the frequency counter setting menu.
To Enable or Disable the Frequency Counter
In the "Counter" setting menu, click Counter continuously to enable or disable the
frequency counter measurement. When enabled, the following figure is displayed.
To Select the Measurement Source
Click Source to select the desired source. The analog channels (CH1-CH4) and EXT
can all be selected as the source of the frequency counter.
To Select the Measurement Item
The measurement items supported by the frequency counter of this oscilloscope
include Frequency, Period, and Totalize measurements. Wherein, Totalize indicates
the count of edge events on the signal.
Click Measure in the "Counter" menu to select the desired measurement item.
To Next Page
Loading...
Need help?
General
