Rigol DS8000-R Series User Manual

RIGOL Chapter 19 System Utility Function Setting
19-2 DS8000-R User Guide
Remote Interface Configuration
DS8000-R series can communicate with the PC via the USB, LAN, or GPIB (requiring
to work with RIGOL's USB-GPIB interface converter) interface. Before using the
remote interfaces, configure the corresponding interface according to the
introductions in the following section.
Click on the function navigation icon at the lower-left corner of the screen to
open the function navigation. Then click on the "Utility" icon to enter the "Utility"
setting menu. Click LAN to set the interface.
LAN Configuration
Before using the LAN bus, use a network cable to connect the oscilloscope to your
local area network. The network interface of the oscilloscope is on the rear panel.
Click IO → LAN to open the LAN Settings interface, as shown in the following figure.
You can view the current network settings and configure the network parameters.
Figure 19-1 LAN Network Connection Setting Interface
Network Status
Different prompts will be displayed according to the current network connection
status.
⚫ Network Config Succeeded!
⚫ Acquiring IP...
⚫ IP Conflict!
Network Status
Current IP Config.
Type
MAC Address
VISA Descriptor
IP Config. Type
Network Parameters
Web Control Info.

Rigol DS8000-R Series Specifications

General

Brand	Rigol
Model	DS8000-R Series
Category	Test Equipment
Language	English