Rigol MSO7000 Series User Programming Manual

RIGOL Chapter 2 Command System
2-12 MSO7000/DS7000 Programming Guide
:BUS<n>:PARallel
The :BUS<n>:PARallel commands are used to set relevant parameters for Parallel decoding.
Command List:
 :BUS<n>:PARallel:CLK
 :BUS<n>:PARallel:SLOPe
 :BUS<n>:PARallel:WIDTh
 :BUS<n>:PARallel:BITX
 :BUS<n>:PARallel:SOURce
 :BUS<n>:PARallel:POLarity
 :BUS<n>:PARallel:NREJect
 :BUS<n>:PARallel:NRTime
:BUS<n>:PARallel:CLK
Syntax
:BUS<n>:PARallel:CLK <source>
:BUS<n>:PARallel:CLK?
Description
Sets or queries the clock source of the Parallel decoding.
Parameter
Name
Type
Range
Default
<n>
Discrete
{1|2|3|4}
——
<source>
Discrete
{D0|D1|D2|D3|D4|D5|D6|D7|D8|
D9|D10|D11|D12|D13|D14|D15|
CHANnel1|CHANnel2|CHANnel3|CHANnel4|
OFF}
OFF
Return
Format
The query returns D0, D1, D2, D3, D4, D5, D6, D7, D8, D9, D10, D11, D12, D13, D14,
D15, CHAN1, CHAN2, CHAN3, CHAN4, or OFF.
Example
:BUS1:PARallel:CLK D0 /*Sets the clock source of the Parallel decoding to D0.*/
:BUS1:PARallel:CLK? /*The query returns D0.*/
:BUS<n>:PARallel:SLOPe
Syntax
:BUS<n>:PARallel:SLOPe <slope>
:BUS<n>:PARallel:SLOPe?
Description
Sets or queries the edge type of the clock channel when being sampled by Parallel
decoding on the data channel.
Parameter
Name
Type
Range
Default
<n>
Discrete
{1|2|3|4}
——
<slope>
Discrete
{POSitive|NEGative|BOTH}
POSitive
Remarks
If no clock channel is selected, the instrument will sample when the channel data
jumps during the decoding.
Return
Format
The query returns POS, NEG, or BOTH.

Rigol MSO7000 Series Specifications

General

Brand	Rigol
Model	MSO7000 Series
Category	Test Equipment
Language	English