52
Jun. 2005
CHECKING THE VERSION
NUMBER
After turning on the power, press the [Drums/SFX] button while holding
down the [Reset] and [Play] button to enter the Test Mode.
The following display will appear, and you will enter test mode.
You can check version number in this display.
fig.ver1
SAVING AND LOADING
USERS DATA
Saving Users Data
Saving Registration Sets to a
Floppy Disk
With the settings of Registration buttons [1]–[12] considered as one set, a single
floppy disk can store up to 99 sets of data. We recommend that complex panel
settings or Registrations you wish to keep be saved on disk.
Furthermore, when you save registrations created on the AT-80SL to floppy
disks, you can call up their settings on other Atelier Series instruments and use
the registrations the same way.
1. Make sure that the disk drive contains a disk that was formatted by the
ATELIER.
2. Touch <Registration> on the Main screen.
The sub-window appears.
fig.03-04_55
3. Touch <Save>.
The Registration Save screen appears.
fig.03-09_55
4. Touch < >< > in the screen to select the save-destination
number.
Numbers which have not been used in the saving operation will be
displayed as “-----.”
fig.03-09-2_55
To cancel the Save operation, touch the <Exit> button to close the
Registration Save screen.
5. Touch <Save>.
The Save Format screen appears.
fig.03-14_55
6. Touch <Original> or <R-Series>.
7. Touch <OK>.
Saving of the registration data will begin.
When saving ends, the “-----” in the screen will change to the registration
name that you saved.
If you have assigned a name, the Registration set will be saved to floppy
disk with that name.
Settings Description
Original
Save formats that can be used with the AT-SL Series
When saved in this format, the data can also be used
by AT-45, AT-15 and AT-S Series devices.
R-Series
Save formats that can be used with AT-R Series
devices
To Next Page
Loading...
Need help?
General
