101
Chapter 3 Using the Registration Buttons
Loading Previously Saved Registration
Sets Into the AT-90SL
Here’s how to recall a previously saved Registration set from the floppy disk
into the memory of the AT-90SL. Registrations can be selected in the
following three ways.
Loading a Set of Registrations (Load)
→
p. 101
You can load a “set” (a collection of settings for Registration buttons [1]–
[12]) from floppy disk.
Loading an Individual Registration (Load One)
→
p. 103
Recall the settings of one of the Registration [1]–[12] buttons.
Recalling the Order that the Registrations are Saved on the
Floppy Disk (Load Next)
→
p. 106
Press the [Load Next] button to recall registration sets in the order in which
they are saved on the floppy disk.
■
Loading a Set of Registrations
1.
Insert the floppy disk containing the Registration into the
disk drive.
2.
Touch <Registration> on the Main screen.
The sub-window appears.
fig.03-04_55
NOTE
Be aware that when you
load Registrations from a
disk, the Registrations that
were previously in internal
memory will be lost. It is a
good idea to save
important Registrations to
floppy disk (p. 98).
You can also open the
Registration Load screen by
pressing the [Registration]
utton, instead of
performing steps 2 and 3.
Min
Max
Min
Max
Min
Max
Min
Max
Harmony Intelligence
AT-90SL_e.book 101 ページ ２００４年９月８日 水曜日 午後５時４４分
To Next Page
Loading...
Need help?
General
