199
Chapter 10 Various Other Settings
■
Displaying a Graphic at
Power-up
The AT-90SL allows you to load a favorite graphic into
internal memory, and have it be displayed when the power is
turned on.
1.
Use your computer to create a graphic image file
that meets the following criteria:
2.
Use your computer to save the graphic image file
on a DOS format floppy disk.
3.
Insert the floppy disk containing the graphic
image file into the floppy disk drive of the AT-
90SL.
4.
Touch <System> on the Main screen.
The System screen appears.
5.
In the System screen, touch <Utility>.
6.
Touch <BMP Installer>.
The BMP Installer screen appears.
The AT-90SL can store up to three images. If two or more
images are stored in internal memory, those images will be
displayed consecutively after the power is turned on.
7.
In the screen, touch <01>–<03> to select the
destination at which the image is to be saved.
fig.
8.
Touch <Load...>.
The BMP Load screen appears.
The name of images saved on the floppy disk will be
displayed.
Size 320 x 240 pixels
Color 8 bit (256 colors)
Format image saved in BMP format
Name 1–8 characters in length (lowercase is ok). A
filename extension of “.BMP” (uppercase
characters) must be added after the name.
The following characters can be used to
name an image.
A B C D E F G H I J K L M N O P Q R S T U
V W X Y Z a b c d e f g h i j k l m n o p q r s
t u v w x y z 0 1 2 3 4 5 6 7 8 9 # $ % & ‘ ( ) -
@ ~ { } ^ _ !
NOTE
If you use a character that cannot be used
in a name, it will be replaced by another
character when displayed.
Display
Explanation
01–03
Images stored in internal memory
View
View an image stored in internal memory.
Load...
Load an image from floppy disk into
internal memory.
Clear...
Delete an image from internal memory.
Min
Max
Min
Max
Min
Max
Min
Max
Harmony Intelligence
AT-90SL_e.book 199 ページ ２００４年９月８日 水曜日 午後５時４４分
To Next Page
Need help?
General
