21
Changes due to the upgraded editor software
Here’s how patches, rhythm sets, multisamples,
and samples placed in the following directory
using Fantom-X Sample Converter can be
imported into the FANTOM-XR.
fig.06-05.e
* If you used Fantom-X Sample Converter only
to convert partials or samples, load them using
Import Audio. (Owner’s Manual; p. 121)
* If this directory does not exist, use your
computer to create it.
1.
In the Patch Play screen (Owner’s
Manual; p. 40) or the Performance Play
screen (Owner’s Manual; p. 84), press
[MENU].
The Top Menu screen will appear.
2.
Press or to select “Utility,” and
then press [ENTER].
The Utility Menu screen will appear.
3.
Press or to select “Import
Patch/Rhythm,” and then press
[ENTER].
fig.06-02
The Import Patch/Rhythm screen will
appear.
* From this point onward, the screens are shown
in “wizard” format to guide you through the
process.
4.
The screen will indicate STEP 1.
The FANTOM-XR will check whether there
are any files that can be imported. If such files
are found, the number of Patches/Rhythm
Sets/Multisamples that can be imported from
User and/or Card will be displayed.
Press [GROUP] to select the group
containing the file you want to load.
USER:
User
CARD:
Memory card
* If there is no data that can be loaded, the
“Import File Not Found” message will appear.
If neither User nor Card contains data that can
be imported, press [EXIT] to cancel the
operation, and use Fantom-X Sample Converter
to place the appropriate data where needed.
5.
Press [ENTER].
6.
STEPS 2–4 will appear.
Turn the VALUE dial or use [INC][DEC] or
to select the starting number of
the write destination for patch,
multisample, and rhythm set respectively.
(The user or card data will be overwritten
by the imported data.)
If you specify a high number as the starting
number, the imported patches, rhythm
sets, and/or multisamples may exceed
their maximum numbers
, making them
impossible to import the remains.
In this case the display will indicate “USER
256 - ***” in step 8.
You can’t change the write-destination
group (User/Card). It will be the same as
the loaded group.
Sample data will be assigned automatically
to numbers at the write destination.
If there is no data to import, a screen like
the following will appear. Press [ENTER]
to proceed.
fig.06-03
Importing patches and
rhythm sets
ROLAND
(User, Card)
TMP
PNL
SEQ
SMPL
SND
PATCH_IMPORT
(IMPORT.SVD etc.)
BMP
TEXT
AUDIO_IMPORT
Fantom-XR-V2_e.book 21 ページ ２００７年５月２２日 火曜日 午前１１時１分
To Next Page
Loading...
Need help?
General
