138
Chapter 10. Detailed Editing for Performances
Parts 1–16 of a performance correspond to MIDI channels 1–16 of MIDI messages received from an external MIDI device.
For each channel you can specify whether MIDI message reception will be enabled (on) or disabled (off). You can also enable reception for only
specific types of messages.
MIDI FILTER Screen
fig.disp-midifilter.eps
In the PERFORM PLAY screen, press [5 (MIDI)].
Use the cursor buttons to select the parameter that you want to edit, and use the
VALUE dial or [DEC] [INC] to turn reception on (
✔
shown) or off (
✔
cleared).
When you’ve finished making settings, press [7 (EXIT)]. You will return to the
PERFORM PLAY screen.
Enabling/Disabling Reception of Messages for Each MIDI Channel (Part)
Parameter Value Explanation
Rx
OFF, ON (
✔
)
Enables/disables MIDI message reception for each part.
If this is OFF, that part cannot be played. Normally, you can leave this ON, but you can
turn it OFF if you don’t want a specific part to play.
PC
(Program Change)
OFF, ON (
✔
) Enables/disables reception of the specific MIDI message for each MIDI channel.
BS
(Bank Select)
PB
(Pitch Bend)
PA
(Polyphonic Key Pressure)
CA
(Channel Pressure)
Md
(Modulation)
Vo
(Volume)
Pn
(Pan)
Ex
(Expression)
Hd
(Hold 1)
JUNO-STAGE_e.book 138 ページ ２００８年１０月１７日 金曜日 午後１２時２７分
To Next Page
Need help?
General
