Roland RD-800 Guide

12
Modulation FX Parameters
16: AUTO PAN
Cyclically modulates the stereo location of the sound.
L in
R in
L out
R out
Auto Pan
2-Band EQ
2-Band EQ
Auto Pan
Parameter Value Explanation
Switch OFF, ON Turns the eect on/o.
Depth Knob
RATE, DEPTH
Species the parameter that is
controlled by the MODULATION FX
[DEPTH] knob.
Rate Knob
Species the parameter that is
controlled by the MODULATION FX
[RATE] knob.
Mod Wave
TRI,
SQR,
SIN,
SAW1,
SAW2
Modulation wave
TRI: triangle wave
SQR: square wave
SIN: sine wave
SAW1/2: sawtooth wave
SAW1 SAW2
R R
L L
Rate (sync sw) # OFF, ON
If this is ON, the modulation is
synchronized to the tempo of the
rhythm (owner’s manual p. 24).
Rate (Hz) #/
Rate (note) #
0.05–10.00 [Hz]
Frequency of the change
note (p. 31)
Depth # 0–127 Depth to which the eect is applied
Low Gain -15–+15 [dB] Gain of the low range
High Gain -15–+15 [dB] Gain of the high range
Level 0–127 Output Level
17: SLICER
By applying successive cuts to the sound, this eect turns a
conventional sound into a sound that appears to be played as a
backing phrase. This is especially eective when applied to sustain-
type sounds.
You can use MFX CONTROL to restart the step sequence from the
beginning (p. 31).
L in
R in
L out
R out
Slicer
Slicer
Parameter Value Explanation
Switch OFF, ON Turns the eect on/o.
Depth Knob
RATE,
ATTACK,
SHUFFLE
Species the parameter that is
controlled by the MODULATION FX
[DEPTH] knob.
Rate Knob
Species the parameter that is
controlled by the MODULATION FX
[RATE] knob.
Step 01–16 0–127 Level at each step
Rate (sync sw) # OFF, ON
If this is ON, the modulation is
synchronized to the tempo of the
rhythm (owner’s manual p. 24).
Rate (Hz) #/
Rate (note) #
0.05–10.00 [Hz]
Rate at which the 16-step sequence
will cycle
note (p. 31)
Attack # 0–127
Speed at which the level changes
between steps
Input Sync Sw OFF, ON
Species whether an input note
will cause the sequence to resume
from the rst step of the sequence
(ON) or not (OFF)
Input Sync
Threshold
0–127
Volume at which an input note will be
detected
Mode
LEGATO,
SLASH
Sets the manner in which the volume
changes as one step progresses to
the next.
LEGATO: The change in volume from
one step’s level to the next remains
unaltered. If the level of a following
step is the same as the one preceding
it, there is no change in volume.
SLASH: The level is momentarily
set to 0 before progressing to the
level of the next step. This change
in volume occurs even if the level of
the following step is the same as the
preceding step.
Shue # 0–127
Timing of volume changes in levels for
even-numbered steps (step 2, step 4,
step 6...).
The higher the value, the later the beat
progresses.
Level 0–127 Output level

Roland RD-800 Specifications

General

Brand	Roland
Model	RD-800
Category	Synthesizer
Language	English