36
Delay Parameters
This is a delay that is applied to the entire Live Set. You can choose from ve types.
You can also adjust the amount of delay that is applied to each layer by editing the DLY (Delay Send Level: owner’s manual p. 28) from each of the layers
Upper 1–3 and Lower.
Settings common to all Delay types
Parameter Value Explanation
Type
DELAY A stereo delay.
T-CTRL DELAY
A delay that allows you to smoothly
change the delay time.
DELAY "
TREMOLO
Tremolo is applied to the delay sound.
2TAP DELAY
Delayed sound is heard from two
locations that you specify.
3TAP DELAY
Delayed sound is heard from three
locations that you specify.
Level 0–127 Delay volume.
1: DELAY
Parameter Value Explanation
Switch OFF, ON Delay on/o
O Mode
IMMEDIATE,
REMAIN
Species what happens to the delay
decays of the previously-played
phrase when you turn delay o.
IMMEDIATE: The delay sound
disappears immediately.
REMAIN: The delay sound decays
naturally.
Output Select
MAIN,
REV,
MAIN+REV
Species the output destination of the
sound from the delay.
Delay (sync sw) OFF, ON
If this is ON, the modulation is
synchronized to the tempo of the
rhythm (owner’s manual p. 24).
Delay (msec)/
Delay (note)
1–1300 [msec]
Adjusts the delay time from the direct
sound until the delay sound is heard.
note (p. 31)
Feedback -98–+98 [%]
Adjusts the amount of the delay
sound that’s fed back into the eect.
Negative “-” settings invert the phase.
HF Damp
200–8000 [Hz],
BYPASS
Adjusts the frequency above which
sound fed back to the eect is ltered
out (BYPASS: no cut).
2: T-CTRL DELAY
Parameter Value Explanation
Switch OFF, ON Delay on/o
O Mode
IMMEDIATE,
REMAIN
Species what happens to the delay
decays of the previously-played
phrase when you turn delay o.
IMMEDIATE: The delay sound
disappears immediately.
REMAIN: The delay sound decays
naturally.
Output Select
MAIN,
REV,
MAIN+REV
Species the output destination of the
sound from the delay.
Delay (sync sw) OFF, ON
If this is on, the delay is synchronized
with the tempo.
Delay (msec)/
Delay (note)
1–1300 [msec]
Adjusts the delay time from the direct
sound until the delay sound is heard.
note (p. 31)
Acceleration 0–15
Species the time over which the
current delay time changes to the
newly specied delay time when you
change the delay time.
This changes the speed of the pitch
change as well as the delay time.
Feedback -98–+98 [%]
Adjusts the proportion of the delay
sound that is fed back into the eect.
Negative (-) settings will invert the
phase.
HF Damp
200–8000 [Hz],
BYPASS
Adjusts the frequency above which
sound fed back to the eect is ltered
out (BYPASS: no cut).
To Next Page
Loading...
Need help?
General
