Recording or
Playing a Rhythm
Track
Composing a
Rhythm Track
About composing
About memory (storage)
Moving a measure
Selecting/clearing a track"
Composing (when the compose
mode is “ORG”)
8
You can compose (assemble) a
rhythm track by successively switching
between rhythm patterns during
playback
A track does not store the actual
rhythm patterns that are played.
Instead, it contains the rhythm select
switch numbers (basic rhythm, intro/
fill-in) that are written in the rhythm
patterns, the number of measures,
and the order in which they are
played; this data is stored for each
measure.$
During track play, you’ll need to set the
basic (or I/F) variation switch as it was
when you composed the track.
1. Hold down the [START/STOP]
button and press a [1]–[10] button to
select the move-destination. Press the
[16] button to move the measure to the
last measure. $
2. Release the [START/STOP] button
to confirm the operation.$
You can also select the destination by
turning the [FINE] (VALUE) knob. $
1. From the stopped condition, set the
mode switch to the rhythm track
“COMPOSE” position.
2. Set the select switch to the desired
position. 3. Press the [CLEAR] button.
4. Specify measure 1, and press the
[START/STOP] button.
The rhythm starts.
5. While listening to the rhythm, switch
between the BASIC RHYTHM [1]–[12]
buttons (or the INTRO/FILL IN [1]–[4]
buttons and [TAP] button).
6. When the last measure to be
composed has played, press the
To Next Page
Loading...
Need help?
General
Weight and Dimensions
