20
Chapter 1. Playing Sounds
Using the PATCH/VALUE dial to
change
Here’s how you can change from one patch to the next one.
* If the System parameter “DIAL” is set to “VALUE ONLY,”
the PATCH/VALUE dial cannot be used to select patches.
1. Make sure that you are in Play page.
If you are not in Play page, press [EXIT] several times.
2. Turn the PATCH/VALUE dial to change patches.
Turning the PATCH/VALUE dial toward the right will
select the next-numbered patch; turning it toward the
left will select the previous-numbered patch.
fig.1-26
Using pedals to change
This method is convenient during a live performance or in
the studio. You can press pedals to specify the bank and
number.
If you set the System parameter “BANK AREA,” patches will
change within the specified bank area.
1. Make sure that you are in Play page.
If you are not in Play page, press [EXIT] several times.
2. Select the patch bank.
Use [BANK ▼] [BANK ▲] to select the desired bank.
* If you do not need to leave the currently selected bank, this
step is not necessary. Proceed to Step 3.
fig.1-27
3. Step on a number pedal [1]–[4] to select a patch
number.
fig.1-28
To Next Page
Loading...
Need help?
General
