Please Read This First
In order to get the best result in using the V-Bass, please note the following points.
●
About the GK Settings
A tonal quality of the V-Bass changes significantly, depending on a condition of the divided pickup installation.
You can effectively compensate for such divergences in tonal quality by setting up the unit with an information
of your bass, such as number of strings, scale length, etc.
Please be sure to adjust each of the GK Settings parameters properly.
(Please refer to “Chapter 1. Playing Sounds” for details.)
A scale is shown below. Use this when making the necessary measurements.
fig1.1
●
About the select switch on the GK-2B
Basically, the select switch on the GK-2B should be set to the MIX position.
You cannot use the GK VOL when the switch is set to the BASS position
(It will work the same way as if you turned the GK VOL to the minimum position).
Also, the input signals from the BASS INPUT jack will be muted, when the switch is set to the GK position.
●
About the connection to the BASS INPUT
You cannot use the COSM BASS function, when you are connecting your bass to the BASS INPUT with a
standard phone cable only, and not using the GK cable.
Also, please do not connect two different basses at the same time using GK cable and standard phone cable.
●
About the OUTPUT jacks (XLR)
You cannot control the volume with the OUTPUT LEVEL knob.
Please use the GLOBAL LEVEL in the SYSTEM settings, in order to adjust the output level from the OUPUT
jacks (XLR), depending on an input level of a connected device.
Please refer to the SYSTEM section of “Chapter 5. Parameter guide” for details.
10
20
30
40 50 mm
To Previous Page
Loading...
Need help?
General
