162
Source
Specifies the data to be transmitted through combinations as
shown below.
For instance, if you wish to transmit the settings of the cur-
rent Performance and the Patch or Rhythm Set assigned for
each Part, specify “PERFORM TEMP:+PATCH.”
1: All Patches, Performances and Rhythm Sets in USER
group
2: The current Performance, Patch and Rhythm Set
3: The Performance of the specified number in USER group
4: The current Performance
5: The current Performance and the Patch or Rhythm Set
assigned to each Part of the Performance
6: The current Performance’s Bank Select and Program num-
bers, as well as Volume and Pan messages of Parts with the
Rx switch ON. Use this selection when you want to make a
rough recording of Performance settings balance. Since data
is transmitted as controller numbers, the data amount will
stay relatively small.
7: The Patch of the specified number in USER group
8: The current Patch
9: The Rhythm Set of the specified number in USER group
10: The current Rhythm Set
11: System
✳ Number 6 cannot be selected from Patch mode. In
addition, Volume and Pan messages to be transmitted
are not part of the selected Performance data; they are
global settings for the entire XP-80 instead. To check
the data, use the Part Information display (PER-
FORM/Info).
Destination
“to Seq” means that data will be transmitted to the internal
song.
Here you can also specify the Phrase track or Pattern to
which the data will be sent, and the Song position (measure-
beat-clock) in that track or Pattern. Phrase tracks or Patterns
containing no sequencer data cannot be selected.
<Procedure>
❶ Make sure that the Utility Menu (UTILITY) is up.
❷ Press [F6] (Menu) to select Menu 1, then press [F4]
(Xfer) to select Data Transfer.
You can also select Data Transfer by moving the cursor to “4
Data Transfer” and pressing [ENTER] on the Utility Menu
display (UTILITY), or pressing the numeric key [4], then
[ENTER].
❸ Press [F2] (to Seq) to call up the Data Transfer to Seq
display (UTILITY/Xfer).
❹ Move the cursor to “Source” and specify the data you
want to transmit.
❺ Press [d] to move the cursor and select the Phrase
track or Pattern to which you want to transmit data.
You can also select a Phrase track by pressing TRACK/
PART [1]]–[16].
To select a Pattern, press [PATTERN] and specify the Pattern
number.
❻ Press [r ] to move the cursor and specify the Song
position in the selected track or Pattern to which data
will be transmitted.
❼ Press [F6] (Execute) to transmit the data.
While data is being transmitted, the display will read
“Transmitting...”
✳ To interrupt data transmission, press [EXIT].
Transmitting data to user memory
You can transmit Patch, Performance or Rhythm Set settings
to the user memory and System settings to the system mem-
ory. By loading sound data from disk or Expansion Boards
to user memory, you can add many different sounds to your
performance.
✳ If you wish to transmit an entire data file, use the Load
function (Disk/Load).
Source
Specifies the data to be transmitted through combinations as
shown below.
For instance, if you want to transmit Rhythm Set 001 of the
Expansion Board inserted into the XP-80’s EXP-A slot, speci-
fy “RHYTHM XP-A:001-001.”
To Next Page
Loading...
Need help?
General
