Ryobi BDS4600 User Manual

I
END SANDING ON THE SANDING BELT
It is more convenient to sand the ends of long workpieces
with
sanding belt in a vertical
position.
Move the work
evenly across
the
sanding belt. For
accuracy, use a
mitre
gauge.
I
SURFACE SANDING ON
THE
SANDING
BELT
WARNING: To avoid injury from slips,
jams
or thrown
pieces,
adjust
the backstop to clear
the
sanding
surface by
no more than 1.6mm.
When
checking
clearance between
the belt and work support,
press
the belt
flat
against
the metal beneath
it.
Hold the workpiece
firmly, keeping {ingers away
from the
sanding belt.
Keep the
end butted
against
the
backstop
and move
the
work
evenly across
the sanding belt. Use
extra caulion
when sanding very thin
pieces
For sanding long
pieces
remove ihe
r^,ork
support.
Apply only enough
pressure
to
allor,nr
the sanding belt to
remove material.
I
SANDING
CURVED
EDGES
Always
sand
inside curves o. :re i e' iic.- as
shown.
WAHNING: Never attempt to sand
the
ends of a
workpiece on the idler drum. Applying
the
end
of
the
workpiece to the idler drum could cause the workpiece
to
fly
up and
result in an injury.

Ryobi BDS4600 Specifications

General

Brand	Ryobi
Model	BDS4600
Category	Sander
Language	English