Ryobi BDS4600 User Manual

WARNING: For
your
own safety, turn switch
"OFF"
and
remove the
plug
from
power
source outlet before
troubleshooting
your
belt
and disc sander.
TROUBLE
PROBABLE
CAUSE
REMEDY
Motor will not run.
1. Defective
On-Off switch.
Defective
switch cord.
Defective switch box.
2. Burned out
motor.
1. Replace
defective
parts
before
using belt and
disc sander
again.
2.
Consult seller's
service.
Any
attempt to
repair this motor
may create a
HAZARD unless
repair is
done
by a
qualified
service technician.
Consult
the
seller
for
the
nearest stores or
centres
at
which
repair
service
is available.
Machine
slows
down
when
sanding.
1. Timing
belt
is too tight.
2. Applying too much
pressure
to
workpiece.
1. Decrease belt tension, see
Maintenance section,
Removing Pulley Cover and
lnstalling Timing
Belt".
2. Ease
up
on
pressure.
Sanding
Belt runs
off
drums.
1. Not tracking
properly.
1. Adjust tracking,
see
Assembly
section,
"lnstalling
the
sanding
belt
-
Tensioning and
Tracking"
Wood
burns
while
sanding.
1.
Sanding
disc or belt
is
glazed
with
sap.
1. Replace
disc or belt.
Excessive noise.
1. Timing belt too tight.
1.
Decrease belt tension, see
Maintenance
Section
"Removing
Pulley
Cover and
lnstalling
Timing
Belt".

Ryobi BDS4600 Specifications

General

Brand	Ryobi
Model	BDS4600
Category	Sander
Language	English