Salus iT500 User Manual

iT500 User Reference Manual
10
Installing the iT500RX Receiver
Replacing an Existing Programmable Controller with the iT500RX Receiver
1. Turn o the electrical power to your appliance.
Caution: Ensure that the electrical supply to the appliance has been isolated. Failure to completely
isolate the appliance could cause personal injury by electric shock and possible damage
to equipment.
Remove the cover from the existing programmable controller.
2. Note down the wiring sequence and the cable colours connected to the terminals within the electrical
box.
3. Disconnect the wires from the existing programmable controller terminals and remove.
Note: Providing the existing programmable controller was mounted using a standard electrical box, the
iT500RX Receiver will nally mount back onto this.
4. Loosen the screws at the bottom of the receiver unit, unclip the front of the unit and t the back of the
receiver unit to the wall using the ttings supplied.

Salus iT500 Specifications

General

Frequency	868 MHz
Interface	Z-Wave
Control type	Touch
Product color	Black, Silver
Smart thermostat	Yes
Units of measurement	°C
Maximum outdoor range	30 m
Temperature range (T-T)	5 - 35 °C
Battery type	AA
Operating voltage	2 V
Number of batteries supported	2
Handheld remote control	No

Weight and Dimensions

Depth	30 mm
Width	128 mm
Height	95 mm