Section 2K: Using Sprint PCS Ready Link 213
Receiving a SprintPCS Ready Link Call
To receive a SprintPCS Ready Link call:
1. Make sure your phone’s Sprint PCS Ready Link mode is
enabled (see “Setting Sprint PCS Ready Link Mode”on
page 204).
2. When you receive a Sprint PCS Ready Link call from a
contact, “R-Link Call,”the contact’s name, and the Sprint
PCS Ready Link number appear on the display. (You do
not need to take any action to answer the call.)
䡲
When you receive a group call, “Group Call,”the
group member’s name, and the Sprint PCS Ready
Link number appear.
3. If the person placing the call has kept the floor (held the
Ready Link/Memo button), you will see the contact
name and Sprint PCS Ready Link number along with
“has floor,”and you will hear the caller speaking.
4. When the caller finishes speaking and releases , you
will see “Floor is open.”on the display screen. Press and
hold to take the floor and reply to the caller. (You
will see “You have floor.”and hear a tone confirming that
you may speak.)
5. When the conversation is finished, press .
Tip:You can also receive a Sprint PCS Ready Link call with the flip closed.
Press and hold the Ready Link button to take the floor when the floor is open.
Note:You can change the volume and the speaker setting during a
Sprint PCS Ready Link call. Volume:Adjust the voice volume by using the Side
Volume key or by pressing the navigation key up or down except when you
are pressing and holding the Ready Link button. Speaker:Switch the speaker
on or off by pressing the Speaker button ( ).
Sprint PCS Ready Link
To Next Page
Loading...
Need help?
General
