64
When the projection lamp of the projector reaches its end
of life, the Lamp replacement icon appears on the screen
and LAMP REPLACE indicator lights yellow. Replace the
lamp with a new one promptly. The timing when the LAMP
REPLACE indicator should light is depending on the lamp
mode.
Follow these steps to replace the lamp.
For continued safety, replace with a lamp of the
same type. Do not drop a lamp or touch a glass
bulb! The glass can shatter and may cause injury.
Allow a projector to cool for at least 45 minutes
before you open the Lamp Cover. The inside of
the projector can become very hot.
CAUTION
Unplug the AC power cord. Let the projector cool for at
least 45 minutes.
Loosen the three (3) screws that secure the lamp. Lift
the lamp out of the projector by using the handle.
1
3
Replace the lamp with a new one and secure the three
(3) screws. Make sure that the lamp is set properly.
Close the lamp cover and secure the screw.
4
Loosen the screw and open the lamp cover.
2
Connect the AC power cord to the projector and turn
on the projector.
5
Lamp Replacement
CAUTION
Top Control
LAMP REPLACE
indicator
Lamp
Screw
Handles
Screw
Lamp Cover
Screw
Screw
Note:
• When Mode 2 is selected in the Lamp life control menu,
if the projection lamp of the projector reaches its end of
life, the lamp replacement icon appears on the screen,
and the projector is turned off automatically after 3
minutes.
• The Lamp replacement icon will not appear when the
Display function is set to Off (p.46), during "Freeze"
(p.25), or "No show" (p.26).
Lamp replacement icon
Maintenance and Cleaning
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following
information to the dealer.
Model No. of your projector : PLC-WR251
Replacement Lamp Type No. : POA-LMP131
(Service Parts No. 610 343 2069)
To Next Page
Loading...
Need help?
General