SERVICE SCHEDULE
CHART
Hours of operation
A
B
C
0
service
service service
service
50
0 0
100
0
0
150
0
200
0
0
250
0
300
0
0
0
350
0
400
0
0
0
* After completing the first 400 hours operation, repeat the items accor-
ding
to
the service schedule given
in
the above chart.
* Usually B service
is
carried
out
every 100 hours. For a new tractor,
however, B service should
be
carried
out
at the 50 hours service.
DAILY
INSPECTION
1.
Check for leakage of oil, water or fuel, and
if
any repair the part.
2. Check the engine oil, transmission
oil
and cooling water.
If
the quan-
tity
is
not proper, remedy the shortage.
3.
After finishing work, replenish fuel
upto
25
mm
(1
inch) below the
fuel tank filler cap.
4.
After working
in
a dusty place, clean
the
air cleaner element and
after working
in
a place with dry grass, clean the radiator and
radiator screen.
5.
Tighten nuts and bolts.
6.
7.
8.
Make further tightening of the setting bolts of front wheel, rear
wheel, and then of other bolts and nuts.
\~
After working
in
a muddy place, grease the king
pins,front
axle
center pin and brake shaft
via
the grease nipples provided.
Check the tire pressure and adjust
if
necessary.
Check the brake and clutch pedals for free play.
If
it
is
not
as
specified, make necessary adjustments.
9.
All
moving portions must be cleaned and lubricated with engine oil
so
that
they work smoothly. Lubrication has
the
reverse effect
in
an
extremely dry or dusty place. Therefore avoid lubrication
if
working
in
such a place.
-25
-
To Next Page
Loading...
Need help?
General
