satoh Buck S-470D User Manual

4. Cooling water replenishment.
Check that the specified quantity of cooling water is put in and if it
is not, fill with water up to 25.4 mm (1 inch) below the filler cap.
The maximum level of cooling water cannot be filled up in one ope-
ration. When cooling water has been completely drained, fill with
new water, then run the engine at low rev. for a short period and
then fill to the specified level again.
Check the water hose for damage and inspect joint sections for leaks.
NOTE: __________________ ~-------------------
In cold weather, check the specific gravity of the antifreeze water
mixture.
5. Tightening nuts and bolts.
Tighten all nuts and bolts as much as possible because vibration is
always noticed when the tractor is operated. At the same time,
check the ballast weight bolts for tighteness.
6. Greasing.
See page 31, "Greasing diagram".
7. Checking the front hub for end-play.
8. Checking the battery electrolyte.
B-SERVICE (Every 100 hours of operation)
NOTE: ________________________________________ __
Carry it out at the same time as DAI L Y INSPECTION AND A-SERVICE
1. Replacing the engine oil.
The engine oil should be replaced at the first 50 hours service and
again replaced after 50 hours running.
,~ Thereafter, replace the oil every 100 hours of operation.
b
2. Replace the engine oil filter with a new one.
3. Check the specific gravity of the battery electrolyte.
4. Clean the fuel filter.
C-SERVICE (Every 300 hours of operation)
Carry out as follows along with DAI LY INSPECTION, A-SERVICE and
8-SERVICE.
1. Replace the transmission case oil.
2. Clean up the hydraulic oil filter.
3. Replace the oil in the front axle differential case and the front gear
case of the 4-wheel drive tractor.
- 27-

satoh Buck S-470D Specifications

General

Brand	satoh
Model	Buck S-470D
Category	Tractor
Language	English