satoh Buck S-470D User Manual

NOTES: __________________________________________ _
1. Lightly apply the engine oil or grease to the seal surface of the oil
filter before mounting.
2. After the oil filter has been screwed in and the rubber seal comes in
contact with the case surface, screw in the filter 2/3 turn further by
hand.
3. After mounting, start the engine and inspect the seal surface for
leaks.
FUEL FILTER ELEMENT REPLACEMENT
Fuel filter element is inserted in the filter body in the cup. To replace the
element close the filter body cock, loosen the ring nut and remove the
cup. After removing the element clean it or replace it, if necessary. After
installed the cleaned or new element to the filter body, install the
cleaned cup to the body with care about "0" ring and then tighten it
enough. Loosen the air vent screw, open the cock, fill the cup with fuel,
and after confirmed no more air left tighten the ail' vent screw. Ensuring
no fuel leakage is required.
NOTES: ________________________________________ __
In case the engine won't start loosen the fuel pump air vent screw and
purge it of air.
-40-

satoh Buck S-470D Specifications

General

Brand	satoh
Model	Buck S-470D
Category	Tractor
Language	English