satoh Buck S-470D User Manual

F
!
L
2. Before adding mixture of antifreeze and water, completely drain
cooling water and clean the radiator with detergent.
3. Water to be added to antifreeze should be clean and soft water.
4. When antifreeze is no longer used, drain and wash the cooling system
using detergent and fill it again with clean water. Do not re-use anti-
freeze drained from the engine.
5.
Treat antifreeze carefully so that it may not remove paint from the
cylinder block.
6. Any antifreeze solution (antifreeze and water). even if it is perma-
nent antifreeze, should not be used for more than 2 years.
7.
Confirm that there are no leak from the hose joints or cylinder head
gasket.
8. Antifreeze with proper density to suit the climate in your area
$hould be used.
9. When
antifreeze is used over a long period in winter, measure the
specific gravity frequently.
NOTE: ______________________________________ _
Consult your dealer concerning detergent and antifreeze.
FUEL SYSTEM AIR BLEEDING
If fuel is exhausted the engine stops or when the fuel filter element is
cleaned, air is induced into the fuel line. In such a case, the fuel system
must be bled after refilling the fuel tank. If air is left in the fuel line, the
engine cannot be started.
FUEL FILTER AIR BLEEDING
Fill the fuel tank up to the proper level. Loosen the No.1 air vent screw
shown in the following photo and tighten it up after filling in fuel until
no air is noticed. And then loosen the No.2 air vent screw, fill in fuel
until no air is noticed and tiuhten up the air vent screw in the same
manner as for the No.1 screw.
- 33-

satoh Buck S-470D Specifications

General

Brand	satoh
Model	Buck S-470D
Category	Tractor
Language	English