Schenker SMART 60 User Manual

5 – FUNCTIONING AND USE COD: 60S12/24.B.2021
EN
THE PRESENT MANUAL BELONGS TO - Schenker Italia - ALL RIGHTS RESERVED
31
5.3.3 Working cycle with timer
1. Keep ON/OFF pressed for a while, then you
will hear 1-2-3-beeps. Once released ON/OFF,
the watermaker will work for 1-2-3 hours, then
it will flush and stop..
2. The unit can be stopped at any time by
pushing the ON/OFF button (without final
flushing) or the FLUSHING button (with final
flushing).
CAUTION
The unit is based on 2 parallel pumps (pump 1 and pump 2). The unit works normally
with both pumps, producing roughly 50 lit/h and drawing about 240 watt. The unit can
also work with a single pump (either pump 1 or pump 2) producing 25 lit/h and drawing about 110
Watt. The sequence to activate a single pump is indicated below.
5.3.4 Working cycle with single pump
1. Keep ON/OFF and FLUSHING pressed for a
while, then release FLUSHING. Next time
watermaker will started, just Pump 1 will work.
2. Keep ON/OFF and FLUSHING pressed for a
while, then release ON/OFF. Next time
watermaker will be started, just Pump 2 will
work.
CAUTION
After the cycle with a single pump the unit automatically will return to the normal 2 pumps mode.
5.3.5 Long flushing procedure
1. Push FLUSHING. A 3-minute flushing
procedure with fresh water starts. Both ON/OFF
and FLUSHING lights of the buttons are on.
2. The unit can be stopped at any time by pushing
the ON/OFF button

Schenker SMART 60 Specifications

General

Brand	Schenker
Model	SMART 60
Category	Water Filtration Systems
Language	English