Schenker SMART 60 User Manual

5 – FUNCTIONING AND USE COD: 60S12/24.B.2021
EN
THE PRESENT MANUAL BELONGS TO - Schenker Italia - ALL RIGHTS RESERVED
32
5.4 Reset procedure
If the watermaker gets air (or if some other problems occur), the automatic hydraulic valve may stop in a central
position. This means that the working pressure goes up suddenly. After approx. 20 sec. the computer
recognizes the problem and turns off the pumps.
In this case is necessary to reset the valve with the following simple procedure:
1. Turn off the system
2. Open the reset valve (lever in horizontal
position).
3. Open the depressurization valve.
4. Screw the positioner know clockwise until it can
be moved no further. Normally 10 turns at least
are needed.
5. Unscrew the positioner knob counterclockwise up
to the original position, until when it is blocked
back.
6. Close the reset valve (lever in vertical position).

Schenker SMART 60 Specifications

General

Brand	Schenker
Model	SMART 60
Category	Water Filtration Systems
Language	English