SC2 Motorcycle Bluetooth
®
Communication System with Mesh Intercom™ | 10
2 INSTALLING THE HEADSET ON YOUR HELMET
4. Install the SC2 into the helmet.
Click
2.3 Removing the SC2
1. Remove the installed SC2 from the helmet by lifting it up with the SC2
Remote Control cover.
2. Pull the antenna cable retainer out from its original position, and pull out the
connected cables from the upper gap in the space. Then, disconnect the
cables correctly.
Note: When you need to un-plug the connectors, please wiggle and pull
them. It will help the connector connection be released more easily.
To Next Page
Loading...
Need help?
General
