Servonaut M24 User Manual

29
reprogram if necessary. For the M24
without cruise control it should be in the
middle position. Otherwise the model
does not stop if there is bad reception but
continues to drive uncontrolled.
· Reception errors are masked/blinded out in
the receiver. Therefore the Servonaut-
module with its build-in error detection cannot
detect errors and react accordingly, e.g. stop
the model.
· You will not have these problems with Servo-
naut’s Zwo4 2.4GHz radio upgrades.
Anomalies of 2.4 GHz radios
If you use a 2.4GHz radio or a PCM modulation,
the signals are digitally transmitted with a protocol
that allows error detection and correction in the
receiver. Therefore you have to pay attention to
the following:
· The receiver takes a little longer to be ready
after it is switched on.
With cruise control
Some receivers save a fail-safe position
for all channels (see user manual of your
radio), that is active after turning-on and a
certain period of bad reception. The fail-
safe position for the throttle is normally
the centre position – please check and
reprogram if necessary. For the M24 with
cruise control it should be in the lower
position (full brake). Otherwise the model
does not stop if there is bad reception but
continues to drive uncontrolled.
Without cruise control
Some receivers save a fail-safe position
for all channels (see user manual of your
radio), that is active after turning-on and a
certain period of bad reception. The fail-
safe position for the throttle is normally
the middle position – please check and

Servonaut M24 Specifications

General

Brand	Servonaut
Model	M24
Category	Controller
Language	English