To Next Page

To Previous Page

Using any radio with multiswitch

module

If you connect the M24 to a multiswitch channel

you can use the switches/push buttons of the

multiswitch extension of your radio to operate the

light set of the M24.

The M24 detects automatically if you connect the

M24 light cable (Licht/Light) with the white plug of

the receiver and connect it to the multiswitch

channel of the radio. Please note: The multiswitch

channel has to be compatible with Robbe/Futaba

or Graupner/JR-System.

See the following tables for the assignment of the

switches/push buttons.

Please note: The M24 detects if you use a switch

or push button as control. To make that possible

you shouldn’t actuate the switches just briefly, let

them hold the position.

Using the M24 with a multiswitch or HS12

multi channel

If you connect the M24 to a multichannel you can

use the softkeys of the HS12 to operate the light

set of the M24. Just connect the white plug of the

receiver to the multiswitch channel 8 of the Servo-

naut receiver. Set the multiswitch type to Robbe

(Rob.).

The function of the channels x8a to x8h of your

HS12 is the same as the assignment for the

Robbe Multi-Switch (see table page 35). You can

freely assign the channels to the HS12 softkeys.

Please note: The M24 detects if you use a switch

or push button as control. To make that possible

you shouldn’t actuate the switches just briefly, let

them hold the position.

Servonaut M24 User Manual

Questions and Answers: