Sharp ER-A440 User Manual

27
Job-Code-Based Programming
This section illustrates how to program items using job codes. Using job codes allows you to program a wide
variety of items in comparison with direct programming.
Start this programming by entering a corresponding job code as shown below.
All the items which can be programmed by the job-code-based programming are listed on this page and the
following, and those which can also be programmed by the direct programming are marked with the symbol
“ ” that follows job codes.
When setting the parameters for a job code, the digit that is blinking is the one that can be changed.
To go to the position of the parameter that you want to change, press either of the following keys :
.
Moves the blinker to the right.
º
Moves the blinker to the left.
Setting the date
Enter day (one or two digits), month (two digits), and year (two digits) in this sequence.
Date
2610
. ≈
260898
;
PrintKey operation
Example
2610
.
≈
;
Date (five or six digits)
Procedure
Direct2610
PGM 2
Setting the date and time
1
Note
Direct
2110
.
≈
Setting the time
Set the time using the 24-hour format. For example, when the time is set to 2:30 AM, enter 230; and when it is
set to 2:30 PM, enter 1430.
2611
.
≈
;
Time (max. four digits)
Procedure
Direct2611
PGM 2

Sharp ER-A440 Specifications

General

Brand	Sharp
Model	ER-A440
Category	Cash Register
Language	English