Shinkawa VM-5K User Manual

7. PARAMETER SETTING VM-5S
-49-
7-7 GEAR TOOTH FORM SUITABLE FOR DETECTION
The recommended tooth form and dimensions are shown in the drawing below. If the teeth are
smaller than the below dimensions , the amplitude of the detection signal becomes so small that
detection error may result.
(1) Gear
(2) Projection
• To detect a projection (gear), provide surface A of the projection with a concentric
curve. Do not make it flat.
(3) Key groove
(4) Target for rotor speed detection
Input
VK-202A
FK-202F
RD-05A
VK-302P
A ≥6 ≥8
B ≥7 ≥8
C ≥2.5 ≥2.5
Dimension of target
[Recommended](mm)
D ≥16 ≥20
Set gap
[Recommended](mm)
-- 1.0 to 1.5 1.0 to 1.5
D
A
B
C
D
A
C
D
B
C
Mandatory

Shinkawa VM-5K Specifications

General

Brand	Shinkawa
Model	VM-5K
Category	Monitor
Language	English