Installation in XLS housings
2
9 | 34
Building Technologies
2.2 Installation in XLS housings
Figure 2: Installing the Ethernet switch (modular) in XLS housings
1 Housing back box
2 Ethernet switch (modular) with Ethernet modules installed
3 3x fixing screw
4 Fixing slot in side tab
5 Threaded standoffs on back box
1. Position the Ethernet switch (2) as shown.
2. Inserting the 3 fastening screws (3) into the side tabs (4) and screw the Ethernet
switch (2) to the threaded sleeves (5) in the back box (1).
3. Wire up the Ethernet switch according to the wiring information provided below.
1
2
To Next Page
Loading...
Need help?
General
