Installation
102/293 Revision 11 • INSTALLATION AND OPERATING INSTRUCTIONS • NXPLUS C • 802-9081.9
➭ Lift the cable compartment cover and remove it upwards.
➭ Identify the cable compartment cover with the panel number.
➭ Take the transport bolts out and remove the metal plates placed underneath.
➭ Refit the cable compartment cover to keep the panels more rigid for further transport.
Further transport without
wooden pallets
➭ Lift the transport unit by means of a crane, hydraulic jacks or a fork-lift truck with the help of
lifting rods (before lifting, knock the boards marked at the front out of the wooden pallet by
means of a fork-lift truck).
①
"Feeder earthed"
locking device
②
Interlock for cable
compartment cover
WARNING
Heavy weight.
Can cause death, serious injury or property damage.
➭ Observe all handling instructions in this manual to prevent tipping or dropping of
equipment.
CAUTION
Incorrect dimensioning of the lifting tools
Can damage the lifting eyes.
If the lifting eyes are damaged, the transport units cannot be aligned properly with other
switchgear panels.
➭ Maximum permissible angle of lifting equipment at the hook < 60°.
➭ Maximum permissible angle at the switchgear panel > 60°.
➭ Minimum permissible length of the hanging parts > 3000 mm.
INFORMATION
A transport unit standing on roller pads can only be moved straight ahead.
➭ To change the direction, the position of the roller pads must be changed.
To Next Page
Loading...
Need help?
General
