Siemens OpenStage 20 T Operating Instructions

More functions/services
71
Step by Step
Using system functions from outside
DISA (direct inward system access)
If configured (contact your service personnel), you can
use an external phone like an internal station to set up
an outgoing external connection via the system. You
can also activate or deactivate the following system
functions:
• Reset services and functions,
code #0 Æ page 69
• Call forwarding, code
*
1/#1 Æ page 26
• Lock and unlock phone,
code
*
66/#66 Æ page 60
• Save your PIN,
code
*
93 Æ page 62
• Send a message,
code
*
68/#68 Æ page 64
• Leave an advisory message,
code
*
69/#69 Æ page 66
• Ringing group, code
*
81/#81 Æ page 77
• Group call, code
*
85/#85 Æ page 77
• Caller ID suppression,
code
*
86/#86 Æ page 57
• Camp-on tone, code
*
87/#87 Æ page 45
• Open door, code
*
61 Æ page 33
• Release door opener, code
*
89/#89 Æ page 34
• Control relays, code
*
90/#90 Æ page 75
• Do not disturb, code
*
97/#97 Æ page 56
• Ringer cutoff, code
*
98/#98 Æ page 56
• Dial using speed dial, code
*
7 Æ page 40
• Associated service, code
*
83 Æ page 70
Prerequisite: Your phone supports tone dialing (DTMF)
or you can switch your phone to tone dialing. The phone
is not connected to the system.
j Establish a connection to the system. Enter the station
number (contact your service personnel).
j Wait for the continuous tone (if necessary, switch pho-
ne to tone dialing) and enter the internal number assig-
ned to you and the corresponding PIN.
( Enter the code (only required if programmed in the sys-
tem).

Siemens OpenStage 20 T Specifications

General

Brand	Siemens
Model	OpenStage 20 T
Category	Telephone
Language	English