Installing the Device
2
The following sections describe how to install the device, including mounting the de-
vice, installing/removing modules, connecting power, and connecting the device to
the network.
DANGER
Electrocution hazard – risk of serious personal injury and/or damage to equip-
ment.
Before performing any maintenance tasks, make sure all power to the device has
been disconnected and wait approximately two minutes for any remaining energy
to dissipate.
WARNING
Do not disconnect or open equipment unless power has been switched off or the
area is known to be non-hazardous.
AVERTISSEMENT
Débrancher ou ouvrir l'équipment seulement si l'alimnetation a été coupée ou si l'on
sait que la zone ne pose aucun danger.
WARNING
Substitution of the components may impair suitability for Class I, Division 2.
AVERTISSEMENT
Le remplacement de composants pourrait compromettre l'admissibilité à la Classe I,
Division 2.
WARNING
Radiation hazard – risk of serious personal injury
This product contains a laser system and is classified as a CLASS 1 LASER PRODUCT.
Use of controls or adjustments or performance of procedures other than those speci-
fied herein may result in hazardous radiation exposure.
NOTICE
This product contains no user-serviceable parts. Attempted service by unauthorized
personnel shall render all warranties null and void.
RUGGEDCOM RSG2100
Installation Manual, 03/2020, C79000-G8976-1040-17
7
To Next Page
Loading...
Need help?
General