Configuring And Operating The SIMATIC Field PG
3-9
SIMATIC Field PG Manual
A5E00075760-04
Default country code of the Windows 2000 menus, dialogs and keyboard layout is
English. You can set another language and keyboard via the control panel with the
dialog Start >Settings > Control Panel > Regional Options > tab ”General”,
box ”Menus and dialogs”> tab ”Input locales”, box ”Input language”.
Authorization
To use the SIMATIC software e.g. STEP 7 you have to install an authorization,
since it is not possible to run this protected software without authorization. The
authorizations can be found on the Authorization disk that comes with your PG.
To perform the authorization:
• Insert the authorization disk in drive A:
• Click on the Windows ”Start” button and
• select the menu command Simatic > AuthorsW > AuthorsW to open the
authorization tool. It will guide you through the installation routine of the
authorization. Copy the STEP 5 and STEP 7 authorization by selecting “All“.
Notice
The authorization diskette supplied with the PG contains authorizations for the SI-
MATIC software you ordered only. The SIMATIC software you receive will corres-
pond to your order form.
The diskette of the supplied version ”Upgrade Installation” contains only the soft-
ware for upgrading authorizations already preinstalled.
Software without authorizations in the in the scope of supply cannot be used when
installed on the PG.
Keep the Authorization disk in a safe place so that you can save the authorizations
to disk.
Additional software
You can now install the the supplied operating software for the DVD-ROM or the
DVD-ROM/CD-RW drive. Place the CD in the drive and follow the instructions on
the screen
To Next Page
Loading...
Need help?
General
