Configuring the SIMATIC Field PG
5-17
SIMATIC Field PG Manual
A5E00075760-04
5.5 The Power Menu
This menu has the following structure:
PhoenixBIOS Setup Utility
Item Specific Help
ESC Exit
Select Item
Select Menu
+ / –
Select
Change Values
Sub-Menu
F9
F10
Setup Defaults
Save and Exit
Enter
Help
F1
Advanced Security Boot Version ExitMain
[Enabled] [Disabled]
Switch on/off Power
Savings to conserves
system power.
To turn off power
management, choose
Disabled, but remember
Power Button also did
not functioning.
Power
Resume On Time [Off]
Resume Time: [00.00.00]
Hard Disk Timeout: [Disabled]
After Power Failure: [Stay Off]
Power Savings:
[Enabled]
Resume On Modem Ring: [Off]
Fig. 5-12 “Power” Menu
The Power menu offers a number of power-saver modes for environmentally
friendly computing:
Power Savings [Disabled] No power-saving functions
[Customize, Maximum Power Savings, Maximum Performance]
User-selectable and preset power-saving functions
for maximum and minimum power saving.
You can set the parameters for Standby/Suspend
Timeouts and Fixed Disk Timeout or they set
automatically to their defaults.
Major components are shut down in suspend mode. The information needed for
reactivating the programming device is buffered.
Hard Disk Timeout [Disabled] The hard disk does not shut down.
[10, 15, 30, 45] Seconds or
[1, 2, 4, 6, 8, 10, 15] Minutes after the last hard disk access
The next time it is accessed, the hard disk
starts spinning again after a brief delay.
Resume On Time [On] If this function is enabled the
programming device is automatically
switched on at the preset time.
[Off] ’Off’ means this function is disabled.
To Next Page
Loading...
Need help?
General
