Mounting and connecting
3.2 Mounting the HMI device
Basic Panels 2nd Generation
26 Operating Instructions, 10/2016, A5E33293231-AB
Slide the labeling strip
into the device using
the guide, if available.
Insert the HMI device
into the mounting
cutout from the front.
Make sure that
protruding labeling
strips are not caught
between the mounting
cutout and HMI device.
Securing the HMI device with mounting clips
If mounting clips and grub screws are
available separately in the accessory
kit, insert a grub screw into the
mounting clip bore hole and turn it
several times.
Place the first mounting clip into the
corresponding cutout.
Fasten the mounting clip with a size 2
screwdriver. The maximum permitted
torque is 0.2 Nm.
Repeat steps 1 to 3 for all mounting
clips required to secure your HMI
device.
To Next Page
Loading...
Need help?
General
