Siemens SIMATIC HMI KTP1200 Basic DP User Manual

Commissioning a project
6.5 Backup and restore
Basic Panels 2nd Generation
80 Operating Instructions, 10/2016, A5E33293231-AB
6.5
Backup and restore
6.5.1
Overview
Backup and restore
You can back up and restore the following data in the internal flash memory of the HMI
device with a PC:
● Project and HMI device image
● Password list
● Recipe data
Use one of the following tools for backup and restore:
● WinCC
● ProSave
General information
Note
Power failure
If a complete restore operation is interrupted due to power failure on the HMI device, the
operating system of the HMI device may be deleted. In this case, you have to reset the HMI
device to its factor
y settings.
Compatibility conflict
If a message is output on the HMI device warning you of a compatibility conflict during the
restore operation, the operating system must be upd
ated.
Note
A data transfer can take several minutes, depending on data volume and transmission rate.
Observe the status display. Do not interrupt the data transfer.
See also
Data transmission options (Page 75)
Save to external storage medium – Backup (Page 50)
Restore from external storage medium – Restore (Page 51)

Siemens SIMATIC HMI KTP1200 Basic DP Specifications

General

Brand	Siemens
Model	SIMATIC HMI KTP1200 Basic DP
Category	Control Panel
Language	English