Siemens simovert masterdrives User Manual

Parameterization 10.99
6SE7087-6KP50 Siemens AG
8-8 Operating Instructions SIMOVERT MASTERDRIVES
Some parameters may also be displayed without a parameter number,
e.g. during quick parameterization or if "Fixed setting" is selected. In
this case, parameterization is carried out via various sub-menus.
Example of how to proceed for a parameter reset.
P
É Ë
0.0 A 0 V 00
# 0.00 min-1
* 0.00
min-1
Ready
∇
É Ë
P
É Ë
MotionControl
*Menu selection
OP: Upread
OP: Download
Menu Selection
*User Param.
Param Menu..
Fixed Set...
Menu Selection
*User Param.
Param Menu..
#Fixed Set...
2 x
Selection of fixed setting
P
Ë
Fixed Setting
*Select FactSet
FactSet.
P
É Ë
∇
É Ë
Fixed Setting
*Select FactSet
#FactSet.
Factory Setting
FactSet.
*No FactSet
Factory Setting
#FactSet.
*No FactSet
∇
É Ë
Selection of factory setting
P
Ë
Factory Setting
#FactSet.
*No FactSet
busy............
É Ë
Menu Selection
*User Param..
Param. Menu..
FixedSet...
wait
Start of factory setting
It is not possible to start the parameter reset in the "Run" status.
NOTE

Siemens simovert masterdrives Specifications

General

Brand	Siemens
Model	simovert masterdrives
Category	DC Drives
Language	English