Siemens SINAMICS G120C DP Manual

6 Configuration and Settings
6.1 Creating the project configuration
SINAMICS G120 DP at S7-1200
Entry-ID: 70155469, V1.4, 07/2018
53
 Siemens AG 2018 All rights reserved
No.
Action
Remarks
24.
The device and network
configuration is now
completed.
1. Successively compile the
configurations of
SIMATIC CPU and HMI
device for control
purposes. The
compilation results can
be seen in the inspection
window.
2. Save the project.
25.
Now you create the STEP 7 program (programming the OBs, FCs, FBs, DBs) and also
configure the HMI control panel (creating pictures, assigning HMI tags etc.). Then load the
entire software into SIMATIC controller, SIMATIC drive and HMI panel, according to
chapter 3.5.
6.1.2 Change device of SINAMICS G120
It is possible to change the SINAMICS after the configuration.
Table 6-2: change device of SINAMICS G120
No.
Action
Remarks
1.
Select the SINAMICS G120
and open the mask for change.
2.
It is possible to change the
size and the firmware-version
of a SINAMICS G120C.
The firmware-version is
changeable by all SINAMICS
G120.
2
1

Siemens SINAMICS G120C DP Specifications

General

Brand	Siemens
Model	SINAMICS G120C DP
Category	Inverter
Language	English