PLC Subroutines Manual
6FC5397-0FP40-0BA0, 08/2013
7
DB1000.DBB6
DB1000.DBB7
DB1000.DBB8 Feed override value (in Gray code)
DB1000.DBB9 Spindle override value (in Gray code)
DB1000.DBB10
Output (PPU -
> MCP),
DB1100
DB1100.DBB0 LED 8 LED 7 LED 6 LED 5 LED 4 LED 3 LED 2 LED 1
DB1100.DBB1 LED
16
LED 15 LED 14 LED 13 LED 12 LED 11 LED 10 LED 9
DB1100.DBB2 LED
24
LED 23 LED 22 LED 21 LED 20 LED 19 LED 18 LED 17
DB1100.DBB3 LED 30 LED 29 LED 28 LED 27 LED 26 LED 25
DB1100.DBB4
DB1100.DBB5
DB1100.DBB6
DB1100.DBB7
DB1100.DBB8 7 SEG LED 1
DB1100.DBB9 7SEG LED 2
DB1100.DBB10
DB1100.DBB11
DB1100.DBB12 DP 2
2)
DP 1
1)
1)
The decimal point of the 7 SEG LED 1.
2)
The decimal point of the 7 SEG LED 2.
Interfaces where nothing has been entered are reserved for the next version.
You can understand the relationship between the PLC interface addresses and the SINUMERIK 808D MCP from the
following illustration for a horizontal MCP:
Installing the 808D Toolbox
You must install the 808D Toolbox on your PC/PG (PLC Programming Tool). The 808D Toolbox contains the following
software tools and information:
● Config Data 808D
– System software update
– Examples (EasyXLanguage, symbols for MCP customized keys, template for MCP strips, PLC subroutine library)
To Next Page
Loading...
Need help?
General
