Siemens SINUMERIK 840D sl Ctrl-Energy User Manual

Parameterizing SENTRON PAC
You have the option of parameterizing the measuring device in the following ways:
● Using the input keys and display of the SENTRON PAC
● Using a PC connected to the SENTRON PAC, which has the software this has been
supplied (powerconfig).
After booting select the language and the measuring device is then ready for operation.
3.1.3 Commissioning the PAC PROFIBUS expansion module (840D sl)
To communicate via Profibus, the SENTRON PROFIBUS module in combination with Sentron
PAC3200/4200 must be parameterized differently.
1. Select SENTRON PAC "Settings" > "PROFIBUS modules".
- OR -
For SENTRON PAC4200, select "Settings" > "Expansion modules" > "MOD1" >
"PROFIBUS MODULE".
2. Press "Enter".
You obtain the following information in the subsequent window:
– Order number
– Serial number of the SENTRON PROFIBUS module
– Firmware version of the SENTRON PROFIBUS module
– PROFIBUS ADDR.:
The DP address of module is displayed here.
3. Press "Enter".
This means that you have the option of entering the same PROFIBUS address as in the
automation system.
Ctrl-E Analysis
3.1 SENTRON PAC3200/4200
Ctrl-Energy
14 System Manual, 01/2015, 6FC5397-0EP40-5BA2

Siemens SINUMERIK 840D sl Ctrl-Energy Specifications

General

Brand	Siemens
Model	SINUMERIK 840D sl Ctrl-Energy
Category	Controller
Language	English