4.2 Set license server
You have the following options for operating the license server "Siemens PLM License Server":
● On the server on which SINUMERIK Integrate is already installed
- OR -
● On a separate server
Prerequisite
Ensure that the necessary ports in your firewall are open on the web server and the license
server.
Port settings
To ensure that the license server communicates with the SINUMERIK Integrate server, you
need the following 2 port settings:
● Server Port (standard is 28000): You need this port to perform the setup.
You can find additional setting information in the following chapter: Installing the server
setup (Page 74)
● Vendor Port (standard is 28001): You can configure this port freely.
Information on this can be found in the following directory: SI5\Third-party\Siemens PLM
\Documentation\SPLMLicensing_user_guide.pdf and fnp_LicAdmin.pdf
Note
Web server
If you exchange license files on the web server, you must perform an IIS reset.
Additional information
The "SPLMLicenseServer-Setup" can be found at:
SI5\Third-party\Siemens PLM\SPLMLicenseServer_v9.0.1_win64_setup.exe
A description of the installation can be found at:
SI5\Documentation\SPLM_Licensing_Install.pdf SI5\Third-party\Siemens PLM
\Documentation
Installing/uninstalling/modifying the SINUMERIK Integrate server
4.2 Set license server
Manage MyResources, Optimize MyProgramming /NX-Cam Editor
Installation Manual, 12/2019, A5E44672080B AE 73
To Next Page
Loading...
General
