40 GB/IE
Note: The blank button on the
remote control has no function.
Set up the product as described
in the chapter “Setting up the
product“.
Pl
ug the mains plug
10
into a pro-
perly installed grounded power
socket. Do not use extension
leads or multi-plugs.
Point the remote control
11
in the
direction of the signal receiver
25
and make sure that there are no
obstacles between the two com-
ponents.
Note: You can control the direc-
tion of the air flow by moving the
lever on the ventilation slots
2
.
Using cooling mode
Press the POWER button
28
to switch on the product. The
product switches on and the
display
20
shows the pre-set /
last set temperature.
Press the MODE button
24
repeatedly until the mode indica-
tor
21
shows COOL. The product
is now in cooling mode.
Now set the desired temperature
using the TEMP– button
26
/
TEMP+ button
27
(tempera-
ture range: 16 °C–31 °C). The
set temperature flashes on the
display
20
and is saved after
approx. 5 seconds.
Push the SPEED button
23
to adjust the fan speed. The fan
speed indicator
18
shows the
selected speed (HIGH or LOW).
To turn off the product, press the
POWER button
28
.
Using dehumidification
mode
Note: You can remove the hot air
outlet hose
13
from the product when
operating in dehumidification mode.
For instructions on how to drain
the integrated water tank, see
the chapter “Draining the water
tank“ or “Using continuous water
drainage“.
Press the POWER button
28
to switch on the product.
Press the MODE button
24
repeatedly until the mode indi-
cator
21
shows DEHUM. The
product is now in dehumidifica-
tion mode.
Note: The temperature is auto-
matically set to approx. 2 °C
below the currently measured
room temperature and shown
on the display
20
.
The temperature cannot be set
manually in this mode.
To Next Page
Loading...
Need help?
General
