42 GB/IE
will be cancelled after about
10 seconds. The timer will start
counting down the remaining ti
me
and the product will turn off au-
tomatically when the time is up.
To cancel the timer function, press
the TIMER button
22
once.
Adjusting the air flow
You can adjust the air flow man-
ually by moving the ventilation
slots
2
on the front air outlet
3
up or down.
D
raining the water ta
nk
T
he integrated water tank fi
lls
with water in the following
situations:
– A
t low room temperature and hig
h
humidity, the product may not be
able to evaporate the moisture
quickly enough. If this is the case,
water collects in the water tank.
– If the product is in dehumidification
mode, it draws moisture from the
air in the room. Consequently,
water accumulates in the water
tank. When the water tank is full,
the water tank indicator (W.F)
17
lights up and the error code “E2“
is shown on the display
20
. The
product stops operating.
Proceed as follows to drain
the water tank:
Switch off the product and
remove the mains plug
10
from
the socket.
Pull the hose connector
15
off the
back air outlet
7
and remove
the hot air outlet hose
13
from
the product.
T
ake the product to a place wh
ere
water can drain properly.
Pull the drain plug
8
(as well
as the inner plug beneath it) out
of the opening and allow the
water to drain (see fig. I).
Insert both drain plugs
8
back
into the opening properly. Once
the product has been connected
to the power supply and the hot
air outlet hose
13
has been re
at-
tached, it can resume operati
on.
Using continuous
water drainage
If the product is mainly being used
in dehumidification mode, it is pos-
sible to drain the water continuously
and thus empty the water tank au-
tomatically.
S
witch off the product and rem
ove
the mains plug
10
from the socket.
Pull the drain plug
8
(as well
as the inner plug beneath it) out
To Next Page
Loading...
Need help?
General
