GB
│
MT
│
61 ■SEMS 1100 A1
Preparing espresso
NOTE
► Always ensure that the espresso sieve +, is clean and free of coffee
powder residues.
1) When the appliance is heated up:
To prepare an espresso, place the small espresso sieve , into the sieve
holder%.
To prepare two espressos, place the large espresso sieve + into the sieve
holder %.
2) Fill the small espresso sieve , with espresso powder up to the Max marking.
This corresponds to approx. 7 g of powder or a level measuring spoon .
Or:
Fill the large espresso sieve + with espresso powder up to the Max marking.
This equates to about 7g + 7g of powder or two level measuring spoons .
3) Tamp down the espresso powder using the compactor on the measuring
spoon . Add more espresso powder, if required, until the espresso sieve +
, is full up to the Max marking. Tamp the coffee powder down once again.
NOTE
► Compaction of the coffee powder is an essential process for the preparation
of an espresso. If the espresso powder is compacted very strongly, the
espresso runs through more slowly and more crema is generated. If the
espresso powder is not so strongly compacted, the espresso runs through
more quickly and it creates very little crema.
4) Place the sieve holder % in the appliance at the “
INSERT” mark, then
turn it clockwise until the handle of the sieve holder % is facing the front
(“
LOCK” mark).
5) Place one (or two) cup(s) under the sieve holder openings. We recommend
that you rinse the cups out with hot water beforehand, so that the espresso
does not cool so quickly. You can place the cups onto the storage space .
6) As soon as the green heating-up control lamp
! lights up, you can press
down the “Espresso” button
0. The espresso flows into the cup(s).
WARNING
Never remove the sieve holder % while the espresso is coming
out!
The resulting spray of hot espresso would lead to injury!
► Always check to make sure that the "Espresso" button
0 is not pressed
in before removing the sieve holder %.
To Next Page
Loading...
Need help?
General
