b. Insert the harness connector with the white wire into the P3 connector. Note that the P3 connector has eight pins. Insert the harness
connector on either the top four pins or the bottom four pins, not in the middle.
Figure 10: Power and Communication Wiring for Motherboard (4100U/4100ES)
Installing Motherboards into 4010ES Back Boxes
The zone modules can be mounted to 4100 Back Boxes (PID series 2975-91xx), 4100U/4100ES Back Boxes (PID series 2975-94xx) or 4010ES back
boxes.
• 4100-5001, 4100-5004, 4100-5011, and 4100-5014 modules mount in 4100 Back Boxes.
• 4100-5005 and 4100-5015 modules mount in 4100U/4100ES Back Boxes.
• 4010-9920 and 4010-9921 modules mount in 4010ES Back Boxes
This section describes mounting the 4010-9920 and 4010-9921 versions into 4010ES Back Boxes.
Installing in a 4010ES Panel
The 4010ES Zone Card assembly is composed of a 8V DC Converter Assembly, the Zone Card and the Zone Card Motherboard. The 4010ES Zone Card
assembly can be of Class A (4010-9921) or B (4010-9920). See Figure 11 and Figure 12 for details.
The 8-Volt DC-to-DC Converter takes 24 VDC power from a system switching power supply and converts it to 8 VDC. The Converter is used when
additional 8V power is required.
Class A or Class B 8 Zone Card Assemblies must be mounted inside the top bay of the 4010ES panel. They occupy the leftmost vertical block pair in the
top bay (Figure 13), making the two left-most PDI blocks unavailable.
page 10 579-205 Rev. H
4010ES and 4100 4120-Series Class A/Class B Zone Modules Installation Instructions
To Next Page
Loading...
Need help?
General
