Simplicity 9518 Series User Manual

OPERATION
should be increased at short intervals until at end of
approximately 100 hours engine can be operated at
rated loads. The load on engine can be decreased or in¬
creased by selecting a lower or higher transmission
speed.
An engine should never be used on a load that would
cause it to lug. This would be considered an overload.
The throttle should be in full speed position on any
load during or after the break-in period. Reducing
engine speed on light loads may create a lugging condi¬
tion. Reduced engine speeds may be used to limit
travel speed if lugging is avoided.
The balance of the tractor is also broken-in during this
interval and proves beneficial to such parts as brakes,
gears, bearings, etc. During this interval all external
bolts should be checked for torque or tightness. All
mating parts, gaskets, etc., take a set during this
period and if all bolts are kept tight they will stay tight.
If allowed to work loose for any length of time it will be
impossible to keep them tight.
For proper break-in the following suggestions are
made for best results;
1. Make certain that all points of care and lubrication
outlined under “Lubrication and Service Guide”
have been serviced as specified.
2. Maintain engine speed slightly above rated RPM by
selecting a gear to match the load for the first 100
hours of operation.
3. Drain the engine break-in oil at the end of the first
20 hours of operation and refill with an oil of the
recommened viscosity for the prevailing tempera¬
ture. Change the engine oil filter also.
ENGINE CLUTCH PEDAL
This pedal is provided for engaging or disengaging
power of engine from transmission and is used when
shifting gears.
The clutch is adequate for many hours of normal use,
but if abused or incorrectly used in any manner, its life
can be drastically shortened. The clutch should never
be slipped when starting loads and loads must be start¬
ed at reduced engine speed. If clutch is used as a
speed reducer, or for starting loads under full engine
power, its life will be drastically shortened.
AVOID using engine clutch pedal as a foot rest.
GEAR SHIFTING - TRANSMISSION
The transmission has a shift lever to select the proper
gear speed for the work being done. Before shifting
into any gear, depress clutch pedal fully. Then move
shift lever to the desired gear position.
To shift from one gear to another, shift directly to the
neutral area, then move lever to desired position before
shifting to the next gear. Never force lever from one
gear to another.
There is no detented neutral in the range shift lever,
therfore never leave the range lever positioned between
the range symbols.
COASTING
CAUTION: Under no conditions should the
tractor be towed at speeds over 8 MPH (13
km/h). Never exceed this speed.
If it becomes necessary to tow this tractor follow these
instructions.
1. P lace transmission shift lever in neutral position.
The engine clutch pedal is located to the left and front
of the operator.
SHIFT PATTERN
2. Place PTO shift lever i n neutral position.
3. Place range shift lever in “HIGH”.
TOWING TO START ENGINE
1. Place PTO shift lever in neutral position.
2. Place transmission shift lever in 3rd gear and
range shift lever in “HIGH”
3. Start towing tractor and engage clutch.
4. Never exceed 8 MPH (13 km/h) while towing.
Shift Pattern
37

Simplicity 9518 Series Specifications

General

Brand	Simplicity
Model	9518 Series
Category	Tractor
Language	English