Simplicity 9518 Series User Manual

OPERATION
WEIGHTING THE TRACTOR
Conditions may exist where you will wish to add weight
to the tractor to increase drawbar pulling power and de¬
crease excessive wheel slippage. This additional
weight can be in the form of calcium chloride solution
in the tires, cast iron weight on wheels and front end
weights. The amount you need will depend on your
ground conditions and jobs you are performing.
As weight is added to the rear wheels, the increased
draft force tends to take weight off the front wheels.
CAUTION: Make certain that tractor is
always equipped with sufficient front end
weight to maintain tractor stability and pre¬
vent loss of steering control.
It is recommended that you do not use more weight
than is actually needed to provide reasonable traction.
Total weight on each wheel should not exceed the
recommended load ratings of the tire manufacturer as
listed in column 4 of the “Tire Pressure and Load
Table” for your Tractor Model. On tractors equipped
with ROPS Frame added weight must be limited by the
gross vehicle weight listed below.
WARNING: The optional ROPS frame for
this tractor is designed and manufactured to
meet the requirements of OSHA standard
part 1928, subpart C, for a gross vehicle weight of 2415
lbs. (1075 kg). Exceeding this weight can result in
injury or death if roll-over should occur.
It is also suggested that the added weights be removed
for the light draft jobs such as cultivating, planting,
etc. Carrying unneeded weight will increase soil com¬
paction, waste fuel and reduce life of tires, bearings,
gears, etc.

Simplicity 9518 Series Specifications

General

Brand	Simplicity
Model	9518 Series
Category	Tractor
Language	English