Singer SRP-50 User Manual

10
1
2
3
4
5
6
7
8
9
10
REPACK RIBBER
8
9
A ibber Carriage
Ribber Arm
P Carriage
Swing Handle
Close Knit Bar
Cast-on Comb (long)
Cast-on Wire (long)
Cast-on Comb (short)
Cast - on Wire (short)
Ribber Weight (large)
Edge Weight
Ribber Clamp
1. Disassemble Ribber by reversing the Procedure for as-
sembling. Set Swing Handle at H-1 0 and pull it out in
a rotating manner.
2. Before putting back Needle Bed into the box, fit plastic
packings to both ends of Needle Bed in the following
manner:-
Raise Needle Bed with its Sinker post upward, and its
back side facing you, fit the packings engraved "A" to
right end, and "L" to left end.
t 3. Replace Accessories as shown below.
8
8
5, 6, 7
11 P Presser
' 12
Needle Pusher (2/1, 2/2)
13 Screw Driver
14 Auxiliary Piece (L)
15
Auxiliary Piece (R)
16 Side Hanger
17 Hanger Comb
18 Hook Tool
19 Double-eye Transfer Tool
20
Spare Needle Envelope (incl. 3 needles)
21
Punch Card Set (No.1 (R-2) ~ No.10 (R-2))
- 60 -

Singer SRP-50 Specifications

General

Brand	Singer
Model	SRP-50
Category	Sewing Machine
Language	English